So I bought a prindle 18 last winter for pretty cheap and spent the winter fixing some of the more obvious problems with it, but one issue that's turned out to be a big deal that I hoped wouldn't is the mast step.
The two holes closest to the mast bearing are broken, looks like at some point the mast must have put a lot of pressure on it and it the pin broke out the top of the holes. The previous owner said it wasn't a big deal for him, he just launched the boat, beached it, tipped the boat on its side and put the mast up that way. Well, there aren't really any beaches you can launch a boat off in my area, so yesterday me and two other guys tried to put the mast up manually... we did it, but it was tricky. Taking the mast down was an even riskier maneuver. The attempt at a sailing day was unsuccessful.
So anyone have any pertinent tricks for fixing a mast step? the gap in the top of the holes is only about 5 millimeteres wide... just big enough for the pin to pop out, so I've been debating on trying to weld it instead of paying $120 for a small piece of aluminum.
Anyone have any idea on how to fix a Prindle 18 mast step?
-
- Rank: Lubber
- Registered: Apr 27, 2018
- Last visit: May 03, 2019
- Posts: 6
Posted: May 29, 2018 - 11:45 AM
-
- Rank: Lubber
- Registered: Oct 14, 2014
- Last visit: Jun 08, 2018
- Posts: 22
Posted: May 29, 2018 - 12:46 PM
Pay the $120, if memory serves me right it is cast aluminum, you can't weld cast aluminum and get a solid fix, it will always be weak at that point. -
- Rank: Mate
- Registered: Mar 12, 2003
- Last visit: Feb 19, 2021
- Posts: 879
Posted: May 29, 2018 - 01:17 PM
Take the hinge part off & attach to other side of mast. Pete -
- Rank: Lubber
- Registered: Jul 08, 2017
- Last visit: Jul 01, 2019
- Posts: 22
Posted: May 29, 2018 - 01:19 PM
Possibly have a metal shop roll fabricate a aluminum 4" high 10 gauge sheet to form and fit snugly around the bottom of the mast. drill and rivet in place, add new mast step. This would not be a mast extension but mast wrap.
Edited by gulfstream40 on May 29, 2018 - 02:30 PM. -
- Rank: Lubber
- Registered: Nov 17, 2013
- Last visit: Jul 03, 2020
- Posts: 59
Posted: May 30, 2018 - 03:10 AM
Is it possible to redrill a new hole forward of the broken one. Another option is to add a stainless steel doubler fastened and glued to the casting.
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.