Welcome anonymous guest

Please Support

No more water in the hulls  Bottom

  • I had a small crack under the daggerboard pit. I did a temporary repair from the outside that lasted a few days, then thought to repair it from the inside and threw epoxy all around the pit bottom, with a plastic cup and a brush. I did it both sides. After sailing the hulls came out almost dry, like never seen.. Yes, it’s about time to do a bottom job, but last time I did it I still had more water after sailing. I’m sure it’s a common problem but not such a common solution, so I thought to share. Just put the cup with epoxy inside the hull first (through the inspection port) and then apply.

This list is based on users active over the last 60 minutes.