I just picked up an old H16, the transom was a bit distorted, looking on line it seemed tbe cause would be wet and swollen timber in the transom. I took to it with tbe multi tool and sure enough it was wet swollen and soft. I got to the alloy plate and stopped. I’m assuming there is no timber on tbe otber side of the alloy plate ?
Thanks
Hobie 16 Transom
-
- Rank: Lubber
- Registered: Jul 16, 2023
- Last visit: Jul 16, 2023
- Posts: 1
Posted: Jul 16, 2023 - 02:17 AM
-
- Rank: Mate
- Registered: Aug 01, 2002
- Last visit: Apr 28, 2024
- Posts: 419
Posted: Jul 25, 2023 - 08:46 AM
Correct. The aluminum plate (tapped for the gudgeon screws) is the farthest inside layer of the transom construction.
--
Jerome Vaughan
Hobie 16
Clinton, Mississippi
-- -
- Rank: Chief
- Registered: Apr 19, 2011
- Last visit: Apr 30, 2024
- Posts: 1446
Posted: Jul 25, 2023 - 08:19 PM
So:
1. See where the water is coming in and plug that, unless it's through the transom, then see #2.
2. You talk to someone who knows catamarans (especially Hobie 16s) and fiberglass, and can tell you how to rebuild it. The transom translates a lot of force to the entire boat, and deserves your respect.
--
Sheet In!
Bob
_/)_____/)_/)____/)____/)_____/)/)__________/)__
Prindle 18-2 #244 "Wakizashi"
Prindle 16 #3690 "Pegasus" Sold (sigh)
AZ Multihull Fleet 42 member
(Way) Past Commodore of Prindle Fleet 14
Arizona, USA
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.