In need of sails is there any other cats out there with the same size sail as the 5.7 in need of both main and jib . Would look at good used sails
Thanks Graeme
Canada BC
G cat 5.7 sails 1980-02
-
- Rank: Lubber
- Registered: Aug 20, 2010
- Last visit: Sep 04, 2012
- Posts: 11
Posted: Aug 29, 2011 - 06:08 PM
-
- Rank: Lubber
- Registered: Jun 30, 2011
- Last visit: Jul 26, 2016
- Posts: 22
Posted: Aug 29, 2011 - 07:10 PM
sail specs for 5.0 and 5.7: http://www.thebeachcats.c…loadItem&g2_itemId=80985
--
switched to the dark-side (mutineer 15 mono-hull)
Little Rock Arkansas
-- -
- Rank: Mate
- Registered: Aug 28, 2010
- Last visit: Jul 19, 2016
- Posts: 108
Posted: Aug 30, 2011 - 05:59 AM
A Prindle 18 main sail is a dead match for the G-Cat 5.7 main. The jib is harder to match since the G-Cat jib goes past the bridle and tacks onto the forward crossbeam. You can use the Prindle 18 jib but you give up about 4 square feet of total sail area. (The Prindle jib will tack at the junction of the bridle wires)
I used the P-18 set-up on my 5.7 and it was faster than with the original G-Cat sails, due to the fact that the P-18 sails were built by Randy Smyth. Better cut, better cloth and better battens equals more power! I sold the boat with both sets of sails and the new owner also prefers the Smyth sails over the OE sails.
--
'life is too short to drink cheap beer'
-- -
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Apr 06, 2024
- Posts: 7088
Posted: Aug 31, 2011 - 07:03 AM
a larger sail can be cut down to fit
i sail with a 5.7 that uses a tornado main and full sized jib. the jib blocks have been moved back a foot and are attached via the tramp lacing. -
- Rank: Lubber
- Registered: Aug 20, 2010
- Last visit: Sep 04, 2012
- Posts: 11
Posted: Aug 31, 2011 - 01:48 PM
How much did you have to cut it down by ,would like a biger jib or sail
more HP
-
- Rank: Master Chief
- Registered: Jun 20, 2006
- Last visit: Apr 06, 2024
- Posts: 7088
Posted: Sep 01, 2011 - 07:19 AM
a g-cat 5.7 mast is 28' a Tornado mast is 31'.. so they had a good amount of cutting ot do. Often they convert a pin top to a flat top
First (and 3rd) boat is a g-cat
-
- Rank: Lubber
- Registered: Aug 20, 2010
- Last visit: Sep 04, 2012
- Posts: 11
Posted: Sep 06, 2011 - 08:25 PM
just found an other cat a Sol-cat 18 foot any thoughts or ways to find out how old she is . Only pay $250 for the cat going to redo her for next year. still looking for sails for the G cat 5.7 -
- Rank: Lubber
- Registered: Aug 20, 2010
- Last visit: Sep 04, 2012
- Posts: 11
Posted: Sep 06, 2011 - 09:53 PM
Allso in need of sails for the Sol Cat-18 to both jib and main -
- Rank: Chief
- Registered: Nov 26, 2009
- Last visit: Apr 10, 2024
- Posts: 2524
Posted: Sep 07, 2011 - 07:45 AM
http://boatsafe.com/nauticalknowhow/hin.htm
http://www.thebeachcats.c…n-2c-jib-2c-daggers.html
http://www.thebeachcats.c…-in-great-condition.html
--
Hobie 18 Magnum
Dart 15
Mystere 6.0XL Sold Was a handful solo
Nacra 5.7
Nacra 5.0
Bombardier Invitation (Now officially DEAD)
Various other Dock cluttering WaterCrap
-- -
- Rank: Lubber
- Registered: Aug 20, 2010
- Last visit: Sep 04, 2012
- Posts: 11
Posted: Sep 09, 2011 - 08:40 AM
Is the Sol-Cat 18 the same size sails as the G Cat 5.7? I thought it was just about the same size -
- Rank: Chief
- Registered: Nov 26, 2009
- Last visit: Apr 10, 2024
- Posts: 2524
Posted: Sep 09, 2011 - 11:39 PM
Not sure, I just saw in the post above you were looking for Sol Cat gear
--
Hobie 18 Magnum
Dart 15
Mystere 6.0XL Sold Was a handful solo
Nacra 5.7
Nacra 5.0
Bombardier Invitation (Now officially DEAD)
Various other Dock cluttering WaterCrap
--
Users on-line
- 0 users
This list is based on users active over the last 60 minutes.