My rudder on my 5.2 will not go all the way down. I lack about a quarter of an inch. I tried replacing the tiller arm because it was bent slightly and I thought that would fix it. (The top of the rudder was bumping against the arm inside the casting. ) Well it didn't, now should I try sanding the top of the rudder? Any suggestions or thing to look for? Thanks
--
Nacra 5.2
--
Sanding a rudder
-
- Rank: Mate
- Registered: May 29, 2010
- Last visit: Apr 28, 2015
- Posts: 454
Posted: Feb 19, 2011 - 09:19 PM
-
- Rank: Mate
- Registered: Aug 22, 2007
- Last visit: Jan 07, 2015
- Posts: 742
Posted: Feb 19, 2011 - 11:07 PM
Sounds strange. You could take both rudders out of the castings and lay them on top of each other and see if the holes line up. If not might be necessary to fill and redrill.
--
Rob
OKC
Pile of Nacra parts..
-- -
- Rank: Mate
- Registered: Aug 06, 2004
- Last visit: Feb 24, 2024
- Posts: 877
Posted: Feb 20, 2011 - 08:43 AM
Check and see if the arm is riveted properly in the rudder casting. It sounds like it is sitting a little low.
Users on-line
This list is based on users active over the last 60 minutes.