Welcome anonymous guest

Reply to: P16 - installing bridle on front crossbar

[quote=klozhald]Rather than drill into your crossbar, why not use a removable nylon webbing bridle that attaches around the crossbar next to the hulls on each side? Use a 12' piece of webbing, tie or sew a loop in one end to capture the crossbar and put D rings on the other side to do the same. On the tied end, just pass the loop around the crossbar then thread the other end through the loop. Connect your winch to the center of this webbing and viola! Start yer Wench! The tramp will hold the webbing in place at the ends of the crossbar. Don't forget to gas it in the corners.[/quote]

No HTML tags allowed (except inside [code][/code] tags)

  • Options

  • 0 users

This list is based on users active over the last 60 minutes.