Welcome anonymous guest

Please Support
TheBeachcats.com

Reply to: N5.7 DS rod length.

[quote=waiex191]I can't talk much about the application as I don't have any cat experience other than what I've done on my H16. We have a lathe in our EAA chapter hangar and I use that often, but not for cutting down threads. Generally I'll cut it down and taper the couple of end threads on a bench grinder. If you put a nut on before you make the cut, removing it tends to clean the threads up so it is easy to thread on again. Generally I don't need to resort to pulling out the tap and die set to clean them up.[/quote]

No HTML tags allowed (except inside [code][/code] tags)

  • Options

This list is based on users active over the last 60 minutes.