Welcome anonymous guest

Please Support
TheBeachcats.com

Reply to: Prindle 16 V-bar removal

[quote=texastuma][quote=njcatman]I have been reading about marine grade bronze bushings, where they add aluminum to the mix to reduce corrosion. You have me thinking, though, that I can do it in all aluminum. I can buy 5/16" ID x 3/4" OD spacers that run from the fiberglass deck to the underside of the top of the crossmember. Basically, it will be a 3/4" diameter solid aluminum compression fitting in the crossmember, with the 5/16" bolt going through it. It means making larger holes in the crossmember (3/4"), but it will hold much better than the original. If all goes well, it will be stronger, easier and cheaper. The spacer will need to be in 2 piece to get it in, but the bold will hold it all together.[/quote] Something you may consider is adding a section of aluminum inside the beam as a backing plate also. When you do install the bolts, us a good corrosion inhibitor paste/gel. I use Lanocote and Tuff Gel.[/quote]

No HTML tags allowed (except inside [code][/code] tags)

  • Options

This list is based on users active over the last 60 minutes.

Upcoming Beachcats Events

VIEW FULL CALENDAR

No upcoming events.