Welcome anonymous guest

Please Support
TheBeachcats.com

Reply to: Mast Stepping Nacra

[quote=ericrayl]Hi Rob. Well, I'd take the opposite approach as follows: First pin the shrouds at their loosest setting, so it doesn't take any rig tension at all to pin the headstay. Second, put a temporary pulley somewhere forward and centered, maybe to the jib bridle, maybe to the trailer tongue if it's on a trailer. Third, tie a line to the jib halyard to extend it, run it through said pulley, and back to you at the mast. Raise the mast by hand, lean against it with your shoulder as you take the slack out of the temporary line and tie the line off. I don't know our boat setup, maybe there is a cam cleat facing forward you can use rather than tying a knot. In my Inter 20 the spin halyard clutch works. Pin headstay, then tighten shrouds and pin them. No winches or other stuff involved. Anything you can do to temporarily make the stern higher than the bow makes this easier.[/quote]

No HTML tags allowed (except inside [code][/code] tags)

  • Options

  • 0 users

This list is based on users active over the last 60 minutes.

Upcoming Beachcats Events

VIEW FULL CALENDAR

No upcoming events.