Welcome anonymous guest

Please Support
TheBeachcats.com

Reply to: Converting a port Nacra 5.7/570 hull to use on starboard side

[quote=Edchris177]You will also need to move the two small tabs,(one at each beam) that are attached just below where the beam mounts. There is a small tang on each beam that sits against these tabs. Lastly, but certainly not least is the bridal wire attach point. Have a look at your hull, it is not mound in the center, but set on the inboard side. This needs to be solid, as there is quite a bit of force on that fitting. You cannot get to it without removing the front deck area, as there is a bulkhead below the front beam. You don't say where you are located. There was a good starboard 5.7 hull in Texas, over a year ago, try calling him. [url]http://www.thebeachcats.com/classifieds/catamaran-parts/p11655-parting-out-nacra-5-7.html[/url][/quote]

No HTML tags allowed (except inside [code][/code] tags)

  • Options

This list is based on users active over the last 60 minutes.

Upcoming Beachcats Events

VIEW FULL CALENDAR

No upcoming events.