[quote=Edchris177]Yes, they cut very easily with a cutoff wheel. If you don't have one, a hacksaw works fine, the material is only 304 SS, harder than re-bar, but not like cutting something with chrome in it.
As nhanson says, try to use something as a guide to get a "square cut", then use a b.ast.ard mill file, or grinder to chamfer the edges , just a bit.
Hacksaws tend to wander, you don't want the end cut to be on an odd angle.<!-- editby --><em>Edited by Edchris177 on May 25, 2012 - 09:13 PM.</em><!-- end editby --> [/quote]
No HTML tags allowed (except inside [code][/code] tags)
