[quote=captedteach]It looks like there have been some attempts to patch this before with some crappy methods. I would cut all the BS out plus any glass that is white. A 4 1/2 in Angle Grinder with a 60grit disc will do it fast and a fan blowing it away from you will keep you from getting all itchy. All the glass material should be an amber color to show it was well saturated. Get some Polyester Resin w/hardner, 3- 4oz mat and some 1in chip brushes. Cut strips wider than the area you cut out then pull the glass apart so it does not have a crisp edge. Mix the resin a bit hot - a good squirt vs a few drops. Dont tarry in putting this on the boat wet out the strips until the repair is proud (sticks up) Once it kicks in a hour or so you can grind it fair and finish w gel-coat.
I use waxed paper dixie cups for the resin - pour up three or four half full and add the hardner but dont stir until ready to use[/quote]
No HTML tags allowed (except inside [code][/code] tags)
