|
1: Hobie 16 spinnaker kit contents
Date: 04/11/2005
Views: 6219
|
modifying the rubber things I could not get them around all the block hardware
Date: 04/11/2005
Views: 2016
|
block in place on corner casting after sailing I wish this had a cleat
Date: 04/11/2005
Views: 1961
|
H14 mast tang mounted to mast all the rivets are of the rather large variety I would recomend a very heavy duty rivet tool
Date: 04/12/2005
Views: 2031
|
|
mounting of the tangs on the bows
Date: 04/13/2005
Views: 1844
|
mounting the halyard/tack cleat on the cross bar I put the halyard pulley inside of the cleat it just made more sense as it was
mounting the halyard/tack cleat on the cross bar I put the halyard pulley inside of the cleat it just made more sense as it was going up the mast
Date: 04/12/2005
Views: 2118
|
the end of the pole one end of the tack line is terminated under and around pole at the tack block I had to move the mounting of
the end of the pole one end of the tack line is terminated under and around pole at the tack block I had to move the mounting of the cables going to the bow tangs they were under the tack block this seemed too short so I put an eylet to hold the loop in p
Date: 04/13/2005
Views: 2112
|
the general tramp layout the spin sheet makes a loop like the jib sheet the spin halyard/tack line can be seen going through th
the general tramp layout the spin sheet makes a loop like the jib sheet the spin halyard/tack line can be seen going through the cleat on the cross bar around the tramp and down through the lacing to the spin sock
Date: 04/13/2005
Views: 2075
|