|
Repair1
Fiberglass ground back.
Date: 05/18/2007
Views: 1180
|
Repair 2
Fiberglass wet, all the way through.
Date: 05/18/2007
Views: 967
|
Repair 3
Using a paint scraper to start prying off the deck.
Date: 05/18/2007
Views: 1072
|
Repair 4
Using 2 screwdrivers and a hammer to continue to pry deck off. First screwdriver lifted up near the edge, the second s
Repair 4
Using 2 screwdrivers and a hammer to continue to pry deck off. First screwdriver lifted up near the edge, the second screwdriver lifted up the rest of the lip all the way inside (it was dragged along by the first screwdriver).
Date: 05/18/2007
Views: 1039
|
|
Repair 5
Prying deck up. I loosened it as far forward as the daggerboard well, but stopped there as it seems that the deck is a
Repair 5
Prying deck up. I loosened it as far forward as the daggerboard well, but stopped there as it seems that the deck is attached to the daggerboard well, and I'm not sure how to loosen it there.
Date: 05/18/2007
Views: 979
|
Repair 6
My scraper dug into the lip of the hulls ... will need to repair.
Date: 05/18/2007
Views: 993
|
Repair 7
Inside Nacra hulls, looking forward.
Date: 05/18/2007
Views: 1164
|
Repair 8
Inside Nacra hulls, looking rearward at the bulkhead below the rear beam.
Date: 05/18/2007
Views: 1689
|