logo catamaran sailing at TheBeachcats.com
    
Lost Password?  Register free!

Supporters of TheBeachcats.com

Thanks go to our
Business Sponsors

 

You can help too!

Ad Block
Bottom
Prindle 19 daggerboard question
  • Posted: 03.10.2008, 05:30
     
    rank:
    Lubber Lubber
    registered:
     September 2008
    Status:
    offline
    last visit:
    18.11.08
    Posts:
    7
    My daggerboards have a factory hole whichs lines up with a premolded channel when installed. Is there supposed to be some type of bolt or pin assembly to allow the daggerboards to pivot up in shallow water? I read the online user manual and I didn't find any mention of the daggerboards (centerboards)at all. If there are any P19/18 owners any advice would be helpful. It appears the boards will work fine without the pin....

    --
    Dutch

    --
    Top
  • Posted: 06.10.2008, 07:53
       
    Jmhoying
    rank:
    Lubber Lubber
    registered:
     
    Status:
    offline
    last visit:
    06.10.08
    Posts:
    1
    The daggerboards pivot on a standard piece of 3/4" PVC pipe. They snap into some indents at the bottom of the channel you mentioned. The system works pretty nicely. If you need the exact length of the PVC, I think I have a set here somewhere.
    Jack
    Fort Loramie, Ohio

    --
    Jack Hoying
    Prindle 19
    Fort Loramie, Ohio
    --
    Top